Lionel Zw Repair Manual
The Lionel ZW is Lionel’s most iconic transformer of the 1950s and 1960s, and perhaps one of its most iconic products, period. Everyone wanted the two-handled, football-shaped, 275-watt powerhouse that was the ZW. It was one of Lionel’s more venerable postwar products, lasting on the market for 18 years from 1948 to 1966. It replaced Lionel’s former top-of-the-line transformer, the Z. Finding original ZW instructions or an original ZW manual online is a bit difficult, but there’s plenty the original instructions don’t mention. The Lionel ZW has four sets of variable outputs, four throttles, two whistle/direction controls, a power light, and a short circuit light. The ZW is just like any other transformer in that you need to before you use it.
Also, although a lot of people forget to mention this, it’s important to unplug or otherwise disconnect the power when you’re not using it. I have my transformers plugged into a power strip with an on/off switch so I can switch them all on and off at once. The ZW is cheaper today than it was even a decade ago. Modern transformers with higher wattages put a dent in the ZW’s market and resale value. That said, the ZW is still an excellent transformer.
Pair up a ZW with one of Lionel’s better postwar locomotives like a, and you’ll understand postwar Lionel’s enduring appeal. Sell for $125-$150. As-is or untested can sell for less than $100, depending on what’s missing. A modern-production Lionel ZW-L sells for several hundred dollars. Lights and pinout The ZW has two lights.
The green light is the power indicator. If the transformer is plugged in, you should expect this light to light.
The red light is a short-circuit indicator. Normally you should expect this light to be off. The ZW has four sets of posts on the back.
Posts A-U and D-U correspond to the two big handles on each end. U is the common post, which goes to the outer rail.
Posts B-U and C-U correspond to the two smaller dial controls next to the bigger throttles. Unlike many other Lionel transformers, all of the ZW’s outputs are variable. It doesn’t have any fixed-voltage outputs. Although a ZW can run other makes of trains, be very careful with a ZW and Marx or American Flyer trains.
ZWs can output 20-21 volts, which is well above the 15 volt maximum that Marx and American Flyer motors are designed to handle. Use a if you’re going to run non-Lionel trains. Controls The two large handles on either side normally control your trains. The levers next to the throttle control the direction and the whistle.
Push the lever forward to activate the whistle, and pull the lever back to interrupt power and change direction. Unlike the slightly smaller KW, the ZW can activate both whistles simultaneously if you wish. The two smaller dial controls are less convenient to use for trains and they don’t have a whistle capability or a direction button. To change the train’s direction, you have to turn them down to 0 volts and then back up. Because of this, a lot of people use B-U and C-U for accessories and the other two handles for trains. That said, if you want to run four trains off a ZW, you can. You should consider one thing before you power accessories with a ZW.
When the carbon rollers never roll, they tend to become brittle. The best way to prevent that is to adjust the voltage up or down a half volt every once in a while. Or you can power your accessories with something else. A is ideal, or you can even use a. Common repairs The most common problem I see on the ZW is broken binding posts, which cuts off power to one or more of the controls. There’s an, and a. The is a less common repair, but not expensive.
The whistle control can also get a bit wimpy. You can fix that by replacing the old rectifier discs with diodes, which is something I’ll cover in the near future.
Variations Early ZW transformers from 1948-49 had a 250-watt rating, the same as a Z. They also output slightly higher voltage than later ZWs, with a range of about 7-21 volts. In 1950, Lionel released a revised version with a 275-watt rating. Its voltage output is about 6.5-20 volts. In 1957, Lionel revised the design again.
The ZW-R doesn’t say “R” anywhere on the transformer itself, but the changes made it easier to assemble and theoretically, a ZW-R hums less than an earlier ZW. Lionel also made a VW transformer from 1948-1949.
Lionel Zw Transformer Service Manual
It looks just like a ZW but has a smaller 150-volt rating. Aside from that the Lionel VW is just like a less powerful ZW, with four variable outputs and direction and whistle controls just for the outer handles. The modern-production ZW-L outputs 620 watts.
Lionel Kw Repair Manual
Unlike its vintage predecessor, it has voltage and amperage gauges. Lionel’s release of the ZW-L is one of the reasons vintage ZWs cost less today.